OR NewYear MG
#751
Posted 20 October 2020 - 02:25 AM
#752
Posted 21 October 2020 - 04:37 AM
perpetualKid, on 19 October 2020 - 03:53 AM, said:
If you are interested, the MG fork I'm working on ("Ultimate", see signature) is now running on .NET Core.
While .NET Core is fully supported on Linux (https://dotnet.microsoft.com/download), I've not done any tests for OR MG under Linux and .NET Core, and can imagine a couple areas causing issues. Still I think using .NET Core might be the right aproach for a (native) OR version under Linux.
Hello,
I just sent the attachment in my latest posting (this time I even checked it...); be my guest!
Apart from that I still have problems with running MonoDevelop itself on my Linux system; I may have to clean up the Mono implementation I have. I will report later when I have something significant to say (whether success or failure).
Regards,
#753
Posted 21 October 2020 - 04:40 AM
cesarbl, on 19 October 2020 - 04:31 AM, said:
In comparison, I have found compiling OR on Linux easier. I only installed some NuGet packages in Monodevelop, as far as I remember. I have some problems with the compiled RunActivity executable, but everything else works well both with Wine and Windows.
Cesar,
I seem to have stirred up some hornets nest here... Thanks for your reaction anyway; I will see what I can accomplish here.
Regards,
#754
Posted 21 October 2020 - 04:45 AM
Csantucci, on 19 October 2020 - 02:28 AM, said:
thank you for sharing this to us and I wish you success. There is no attachment in your post however.
Carlo, and other interested parties,
I just tried to put the file in a previous post, but something went wrong there (again...). So here is the next attempt...
orts-problems.pdf (76.75K)
Number of downloads: 19
#755
Posted 21 October 2020 - 12:28 PM
#756
Posted 21 October 2020 - 01:22 PM
No, I was having a reshade configuration problem, but I found the answer in an older post.
I have not heard any more of the NR 3d cab problem.
#758
Posted 22 October 2020 - 09:05 PM
#759
Posted 22 October 2020 - 10:29 PM
#760
Posted 24 October 2020 - 01:17 PM
Csantucci, on 22 October 2020 - 10:29 PM, said:
Ok, so I updated OR to current unstable U2020.10.24-0721, and the locomotive actually loads, the 3D cabviiew has a major stutter (which I think is addressed in the MonoGame version?). Then it hits a critical Out of Memory error as shown a few minutes into running the loco, which I thought was odd , my hardware is pretty capable.
I gave the loco a run on the Australian route in the Open Rails log and the default NEC route just to make sure, and same program-ending message.
Thanks
Attached File(s)
-
OpenRailsLog+CentralWestRoute.txt (92.87K)
Number of downloads: 5