Tenders on Steam Locomotives Tender required or not required
#22
Posted 20 February 2017 - 09:27 PM
#23
Posted 21 February 2017 - 07:43 AM
steamer_ctn, on 20 February 2017 - 09:27 PM, said:
Attached File(s)
-
au_ctn_test_route.zip (18.91MB)
Number of downloads: 251
#24
Posted 21 February 2017 - 12:19 PM
#25
Posted 28 September 2017 - 10:35 AM
#26
Posted 28 September 2017 - 01:34 PM
beresford, on 28 September 2017 - 10:35 AM, said:
In MSTS, if you set the coupling type to "Bar" it cannot be disconnected. I assume that OR is the same.
Coupling ( Type ( Bar )
#27
Posted 28 September 2017 - 02:30 PM
#28
Posted 28 September 2017 - 02:39 PM
ebnertra000, on 28 September 2017 - 02:30 PM, said:
I agree I was not very clear in my first post.
The full loco and tender coupling settings I use are:
Coupling ( Type ( Bar ) Spring ( Stiffness ( 1e6N/m 5e6N/m ) Damping ( 1e6N/m/s 5e6N/m/s ) Break ( 1e8N 1e8N ) r0 ( 10cm 10cm ) ) CouplingHasRigidConnection ( 1 ) Velocity ( 0.1m/s ) CouplingUniqueType (unique_name) ) Coupling ( Type ( Chain ) Spring ( Stiffness ( 1e6N/m 5e6N/m ) Damping ( 1e6N/m/s 5e6N/m/s ) Break ( 1e8N 1e8N ) r0 ( 20cm 40cm ) ) Velocity ( -0.1m/s ) )
Coupling ( Type ( Chain ) Spring ( Stiffness ( 1e6N/m 5e6N/m ) Damping ( 1e6N/m/s 5e6N/m/s ) Break ( 1e8N 1e8N ) r0 ( 20cm 40cm ) ) Velocity ( 0.1m/s ) ) Coupling ( Type ( Bar ) Spring ( Stiffness ( 1e6N/m 5e6N/m ) Damping ( 1e6N/m/s 5e6N/m/s ) Break ( 1e8N 1e8N ) r0 ( 10cm 10cm ) ) CouplingHasRigidConnection ( 1 ) Velocity ( -0.1m/s ) CouplingUniqueType (unique_name) )
#29
Posted 28 September 2017 - 05:20 PM
#30
Posted 28 September 2017 - 05:29 PM