SP 0-6-0, on 03 May 2018 - 12:56 PM, said:
I created a circular flat disk with a turntable sized hole in the center for use a turntable 'skirt' so to speak. As you may imagine It's about impossible to punch a round hole in a terrain mesh composed of triangles! You could not do it in MSTS either so the skirt solution is very easy.
It's textured only on the top side to save polys. I think (but not sure) I used this in 2004 when building the nec4 and takes about 5 minutes to make one using SketchUp. I'll use the surrounding ground texture to 'paint' the skirt.
TT_Skirt.jpg (150.29K)
Number of downloads: 12
Here's a pic of a to-be-textured skirt hovering over the Alto Engine House about to be placed over one of the two new operational turntables at Altoona Pa. on the PRR East Region-2 route upgrade. Yeah, I know I said I'd release when Zoo was done but I couldn't resist including Ron Pikardi's Altoona upgrade also. It was just way too nice to leave out so it's in and scenery / track is being touched up for a smooth ride. Toot Toot!
regards
vince