Matej Pacha, on 04 March 2014 - 10:05 PM, said:
Well, there are two main reasons for this - first is the WAG file friction setting, which can be too high, the second could be the curve friction setting in the ORTS Options menu/Simulation. If you need assistance, the ORTS log file would be very heplful, as well as the WAG file (or just some part of it) used in your activity/run.
Anyway, this behavior is closer to the real world.
Cheers,
Matej
Hi
Here are two of the wagons in the train and log file.
2 engine (SD90) and 124 wagons 8000 ton. I need 60-80% power to move train from stop . No gradient
Thanks for all help.
This simulator is very good and you are doing an incredible job in order to improve the simulator all the time
Looking forward to drive Open Rails 1,0
Wagon 1
Wagon ( TTX_HuskyStack_1a
Type ( Freight )
comment( 24.09t empty, 47.9t full )
Mass ( 47.9t )
)
Velocity ( 0.1m/s )
)
Adheasion ( 0.2 0.4 2 0 )
DerailRailHeight ( 4cm )
DerailRailForce ( 2.5*48t )
DerailBufferForce ( 300kN )
NumWheels ( 4 )
Friction (
495N/m/s 0 1mph 9.96N/m/s 1.8
5.1N/rad/s 1 -1rad/s 0 1
wagon 2
Wagon ( 3dts_spwellcar_china
comment( Flat Car )
Type ( Freight )
comment( 12.97t empty, 50.97t full )
Mass ( 81.97t )
)
Velocity ( 0.1m/s )
)
Adheasion ( 0.2 0.4 2 0 )
DerailRailHeight ( 4cm )
DerailRailForce ( 2.6N/kg*80t )
DerailBufferForce ( 430kN )
NumWheels ( 8 )
Friction (
597N/m/s -0.1 1.5mph 5.14N/m/s 1.938
5.1N/rad/s 1 -1rad/s 0 1
This post has been edited by jorgen: 05 March 2014 - 09:13 AM