I just installed OR v8 updating from OR v7, giving it a test first in West Colton and it would load but then got an error message and it closed. OR v7 ran West Colton fine. So tried v8 in Green River and no problems loading but have a blank space at top of cabview and track showing at bottom. This did not happen in v7.
Still doing some testing and need to try it out in other routes.
Regards,
Pinpuller
Page 1 of 1
OR v8 Cabview Cabview in OR v8
#2
Posted 29 September 2012 - 01:25 PM
If you look down the list a few posts there is a thread covering this problem. Read it for the solution.
Link to the thread:
http://www.elvastowe...blem-in-or-v08/
Link to the thread:
http://www.elvastowe...blem-in-or-v08/
#3
Posted 29 September 2012 - 03:15 PM
spud, on 29 September 2012 - 01:25 PM, said:
If you look down the list a few posts there is a thread covering this problem. Read it for the solution.
Link to the thread:
http://www.elvastowe...blem-in-or-v08/
Link to the thread:
http://www.elvastowe...blem-in-or-v08/
Thanks a bunch Spud. I've GOT to spend more time reading as less time running trains.....Not. Seriously, thanks alot and to everyone else, it did fix the view.
Regards,
Pinpuller
Page 1 of 1