[P Escue]

Is there a way to adjust the sensitivity of the keyboard commands in Open Rails. I’ve tried adjusting in windows with Keyboard Properties, under Speed where you can set the Repeat delay and Repeat rate with no effect in the game. If I press on F or Shift+F for example they zip through their percent of Firing Rate too fast to select anything lower that 50% and most likely 100% or 200%.

Thank you,

Phil

[Weter]

Hello, Phil.
Some of controls can be adjusted by setting third value of *.end-file's entry:
Let's take throttle.

EngineControllers (
    Throttle ( 0 1 0.01 0
         Num notches ( 1
              Notch ( 0 1 dummy)
          )
     )
)

0.01 is the "step"'s size, which lever goes after elementary key press.
Increasing that will cause longer steps = faster movement, and decreasing - slower movement-equivalent effect.

AFAIK, shoveling Showel () control accepts these four values too.

[Aldarion]

"Controls ("

???

not "EngineControllers ( "

?

[Weter]

Sorry. You are right.
Have corrected.

[P Escue]

Thank you for the response.

[Weter]

:)