Elvas Tower: speedometer (pointer) NewYear_MG 64.1 - Elvas Tower

Jump to content

  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

speedometer (pointer) NewYear_MG 64.1 Rate Topic: -----

#11 User is offline   Csantucci 

  • Member, Board of Directors
  • Group: Status: Elite Member
  • Posts: 7,014
  • Joined: 31-December 11
  • Gender:Male
  • Country:

Posted 06 June 2020 - 06:10 AM

The problem with the PKP engine has started with U2020.05.03-1006, which contained changes on diesel power. U2020.04.30-1421 is OK. If the problem is the one that Gerry mentions, I consider modifying the curves a temporary solution until a solution will be found that accepts that Idle and Notch1 have the same RPM number.

#12 User is offline   QJ-6811 

  • Conductor
  • Group: Status: Active Member
  • Posts: 385
  • Joined: 27-December 15
  • Gender:Male
  • Simulator:MSTS / Open Rails
  • Country:

Posted 06 June 2020 - 06:51 AM

 R H Steele, on 06 June 2020 - 05:47 AM, said:

If the locomotive will not move and you are using the ORTS Engine definition, make sure the RPMs for idle and notch1 are not identical.



Thanks! Had it read quickly, but not made the link with this problem.
The first 5 notches (all 496rpm) increased by "+1" every notch, now works fine! (gives power and speedometer remains "present")


:sign_thanks:

#13 User is offline   QJ-6811 

  • Conductor
  • Group: Status: Active Member
  • Posts: 385
  • Joined: 27-December 15
  • Gender:Male
  • Simulator:MSTS / Open Rails
  • Country:

Posted 06 June 2020 - 06:56 AM

 Csantucci, on 06 June 2020 - 06:10 AM, said:

The problem with the PKP engine has started with U2020.05.03-1006, which contained changes on diesel power. U2020.04.30-1421 is OK. If the problem is the one that Gerry mentions, I consider modifying the curves a temporary solution until a solution will be found that accepts that Idle and Notch1 have the same RPM number.


Thanks also for your answer and explanation. (you were just seconds before my answer ...) :D
  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users