The feature is now available in OR NewYear MG rev. 58
Manual shunting using dispatcher window Clearing signals in restrictive aspect
#12
Posted 18 April 2020 - 12:00 AM
In the Czech Republic we use this signal to ride a busy train by train - Red Light + White Flashing light
video is here:
https://www.youtube....h?v=Tbh0LMwEnX4
i use in sigcfg I STOP_AND_PROCEED for manual use
SignalDrawState ( 9 "Priv"
DrawLights ( 2
DrawLight ( 1 )
DrawLight ( 5 SignalFlags ( FLASHING ) )
video is here:
https://www.youtube....h?v=Tbh0LMwEnX4
i use in sigcfg I STOP_AND_PROCEED for manual use
SignalDrawState ( 9 "Priv"
DrawLights ( 2
DrawLight ( 1 )
DrawLight ( 5 SignalFlags ( FLASHING ) )
#13
Posted 18 April 2020 - 01:52 AM
Hi,
does the feature introduced create problems to you?
does the feature introduced create problems to you?
#15
Posted 19 April 2020 - 12:14 AM
#16
Posted 19 April 2020 - 01:37 AM
Hi Howky,
Selecting approach in dispatcher window, as you seem to be doing, bypasses signal logic, and could lead to dangerous situations. With this new feature you can allow a train to enter an occupied track section without neglecting safety.
However, the sigscr must be modified as explained here http://www.elvastowe...post__p__152482. Once this is done, a new option should appear when selecting the signal in dispatcher window, allowing 'CallOn'.
With the modification, the behaviour of CallOn functions is:
Regards,
César
Selecting approach in dispatcher window, as you seem to be doing, bypasses signal logic, and could lead to dangerous situations. With this new feature you can allow a train to enter an occupied track section without neglecting safety.
However, the sigscr must be modified as explained here http://www.elvastowe...post__p__152482. Once this is done, a new option should appear when selecting the signal in dispatcher window, allowing 'CallOn'.
With the modification, the behaviour of CallOn functions is:
- Use on approach to stations
- TrainHasCallOn() and TrainHasCallOn_Restricted():
- Activity: call-on not allowed, unless manually selected from dispatcher window
- Timetable: call-on allowed in specific situations (with $callon, $stable or $attach commands)
- Activity: call-on not allowed, unless manually selected from dispatcher window
- TrainHasCallOn() and TrainHasCallOn_Restricted():
- Use on ‘free line’:
- TrainHasCallOn():
- Activity or Timetable: call-on always allowed
- TrainsHasCallOn_Restricted():
- Activity or Timetable: call-on only allowed if selected through dispatcher window
- TrainHasCallOn():
Regards,
César
#17
Posted 19 April 2020 - 11:29 AM
#18
Posted 20 April 2020 - 07:38 AM
cesarbl
yes I have it undefined, like this, because the Open Rails dispatcher application did not allow it otherwise :)
But with us this signal is used as unsecured ride :)
so mistake can happen :)
yes I have it undefined, like this, because the Open Rails dispatcher application did not allow it otherwise :)
But with us this signal is used as unsecured ride :)
so mistake can happen :)