Hello,
With some cabviews i have problem, if i change cabview the ratio of strech is not like it must be.
Sometimes it is otherwise, when i start game the cabview is streched, and when i change to same cabview in other locomotive it is ok.
I use 1028 by 1024 resolution in options menu. The cabviews use resolutions 2048/2048, 2560/1600...
In 1 of previous versions of ORTS with this problem there is a FOV° message that dissipear after some seconds.
Are there users with same problem?
Page 1 of 1
Cabviewchangeproblem (resolution)
#2
Posted 29 September 2019 - 11:47 AM
I have a similar problem . If I use any form of cab stretch the positions in the " cvf " file are always out of alignment and now instead of resetting the view positions I just don't use stretch anymore . On one PC I use 1080x1024 and 3840x2160 on the other PC . This maybe is not the same as your problem .
#3
Posted 05 October 2019 - 04:51 AM
Hello,
On the .cvf files i use most of time the MSTS default 640 by 480 values.
Greetz
On the .cvf files i use most of time the MSTS default 640 by 480 values.
Greetz
#4
Posted 07 October 2019 - 01:22 AM
The problem should have been solved with unstable release U2019.10.17-0751.
#5
Posted 12 October 2019 - 04:37 AM
Hello,
For Thalys PBA with 2560 by 1600 resolution there is no improvment.
In case that French testlocomotive, there is the problem solved.
Greetz,
Stijn
For Thalys PBA with 2560 by 1600 resolution there is no improvment.
In case that French testlocomotive, there is the problem solved.
Greetz,
Stijn
#6
Posted 12 October 2019 - 10:02 AM
Stjin,
the problem is that OR can't know what is in mind of the cab developer.
Square cabview textures with resolution 1024x1024 or bigger are reformatted in 4/3 format.
The Thalys cabview texture is 2560x1600 pixels, so OR does not reformat it.
the problem is that OR can't know what is in mind of the cab developer.
Square cabview textures with resolution 1024x1024 or bigger are reformatted in 4/3 format.
The Thalys cabview texture is 2560x1600 pixels, so OR does not reformat it.
#7
Posted 13 October 2019 - 03:58 AM
Hello,
For cabviews with HQ resolution, maybe a command (lowercasetoken)
in .cvf file can help?
There must be solution for this no?
Greetz,
For cabviews with HQ resolution, maybe a command (lowercasetoken)
in .cvf file can help?
There must be solution for this no?
Greetz,
#8
Posted 14 October 2019 - 12:03 AM
Hi Stijn,
the solution is that you change the form factor of the .ace file to the one you desire for display. In case the form factor should be 4:3, you can also have a square .ace file.
the solution is that you change the form factor of the .ace file to the one you desire for display. In case the form factor should be 4:3, you can also have a square .ace file.
Page 1 of 1