Log In
Register Now!
Help
Patch uploaded in x.3842.
Brakepipe is loosing the pressure by using the bleed valve
Rate Topic:
#11
- Member, Board of Directors
-
- Group: Status: Elite Member
- Posts: 7,025
- Joined: 31-December 11
- Gender:Male
-
Country:
Posted 01 May 2017 - 12:37 PM
#12
- Open Rails Developer
-
- Group: Private - Open Rails Developer
- Posts: 1,199
- Joined: 04-May 06
- Gender:Male
- Location:Thornton, CO
- Simulator:MSTS - OR
-
Country:
Posted 01 May 2017 - 04:21 PM
If you isolate the car and bleed the air, and then reopen the valve to re-enable the car;s brakes, it will trigger an emergency application as the rest of the train's triple valves detect sudden drop in pressure in the trainline.
Robert
Robert
#13
- Conductor
-
- Group: Status: Contributing Member
- Posts: 472
- Joined: 15-April 13
- Gender:Male
- Simulator:MSTS
-
Country:
Posted 02 May 2017 - 04:22 AM
rdamurphy, on 01 May 2017 - 04:21 PM, said:
If you isolate the car and bleed the air, and then reopen the valve to re-enable the car;s brakes, it will trigger an emergency application as the rest of the train's triple valves detect sudden drop in pressure in the trainline.
Robert
Robert
I see this trigger-effect also, if I close the Bleed Valve, brakes released and a Train with 10 cars with MaxAuxilaryChargingRate( 35 ). I consider this as correct, because of this high chargingRate. The quick charging of the empty Brake-System is reducing the pressure in the brakepipe and this will trigger the triple-valve of the other cars.
In Eng_and_wag_file_reference_guide.doc is written for:
MaxAuxilaryChargingRate( ) Default = 10, typical 5plus.
With MaxAuxilaryChargingRate( 10 ) I can't see a reaction of the other cars
Regards
EugenR