I made an actvity in MSTS many moons ago, where you had to refuel before setting out. I completely forgot about this when running the act in OR.
When i got to my destination, the fuel gauge on the hud said -67 imp gal, but the engines kept on running.
Also, the fuel pump rate when refilling the tanks was set in the MSTS route editor. I had this set quite low so it could take up to 15 minutes to refuel a DMU.
In OR, the refuel took 5 seconds. Can the fill rate be adjusted ?
Any thoughts on this!
Edit
The fuel tank refilling to 176 imp gallons, i could not reproduce it. The consist was a 2 engine DMU. When this did happen, i stopped at the distance required and refueled from the front engine, the rear engine refueled to 176 imp gallons. Tried this a number of times but only the front engine would refuel, i had to swap cabs to the rear engine and refuel from there, where the HUD then showed 146 imp gallons.
Must of been a fluke.
Thanks