Elvas Tower: ER, BP and speed readings are off - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

ER, BP and speed readings are off Rate Topic: -----

#1 User is offline   Claude350 

  • Hostler
  • Group: Status: Active Member
  • Posts: 58
  • Joined: 27-December 10
  • Gender:Male
  • Location:Savannah Georgia
  • Simulator:Open Rails
  • Country:

Posted 03 June 2015 - 11:46 AM

After installing the latest update I noticed that the the brake pipe pressure fills rather quickly on the digital readout while the hud will show a slower or more accurate refill rate. The ER pressure came up much slower than the BP pressure. The speed show about 3 mph faster that what the HUD, the track monitor, and my rail driver displayed. Do the values need to be changed in the engine file and if so what values do I change? I tend to believe it's more an engine file problem since the reading seem to act correctly per the HUD and track monitor. BP is rising real fast and ER real slow for a 7000 ft train. Speed issue could be due to the snow conditions.

#2 User is offline   Claude350 

  • Hostler
  • Group: Status: Active Member
  • Posts: 58
  • Joined: 27-December 10
  • Gender:Male
  • Location:Savannah Georgia
  • Simulator:Open Rails
  • Country:

Posted 04 June 2015 - 07:13 PM

Ok guys. i found that there were some problems with the values in the engine file of this particular loco. I made the adjustments and everything is working as it should as far as the ER and BP rates are concerned.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users