Log In
Register Now!
Help
Hi All,
Haven't seen this yet.
I have a bridge using three pieces of A1tBrdg500r5d track and straight bridge pieces at both ends. I notice this morning that in OR the three curved pieces are regular pieces with ballast and no guard rails. I replace two of the three pieces with a 10d piece but still the same.
In OR:
http://i479.photobucket.com/albums/rr160/paul_charland/203OR_zpsd98be181.jpg
In MSTS and RE:
http://i479.photobucket.com/albums/rr160/paul_charland/203MSTS_zps56a4dd9a.jpg
Paul :-)
Page 1 of 1
Curved Bridge Track
X2319
Rate Topic:
#1
- Vice President
-
- Group: Status: Elite Member
- Posts: 2,531
- Joined: 13-April 08
- Gender:Male
- Location:Brockville, ON, CA
- Simulator:MSTS/OR
-
Country:
Posted 24 October 2014 - 08:37 AM
#2
- Superintendant
-
- Group: Status: Inactive
- Posts: 1,459
- Joined: 14-September 12
- Gender:Male
- Location:Somewhere on the ATSF 4th District
- Simulator:OpenRails
-
Country:
Posted 24 October 2014 - 09:04 AM
That's due to Superelevation. It'll process any curve over a certain length as a superelevated curve and apply the requisite .stf profile...unfortunately, I don't think it detects individual shapes and applies individual profiles just yet.
#3
- Vice President
-
- Group: Status: Elite Member
- Posts: 2,531
- Joined: 13-April 08
- Gender:Male
- Location:Brockville, ON, CA
- Simulator:MSTS/OR
-
Country:
Posted 24 October 2014 - 09:43 AM
The problem is it is changing bridge track to standard track.
Paul
OK, that's what it is in both cases. I change super elevation level back to 0, the gap went away and the bridge track stayed as bridge track... but both are still bugs!
Paul :-)
Paul
OK, that's what it is in both cases. I change super elevation level back to 0, the gap went away and the bridge track stayed as bridge track... but both are still bugs!
Paul :-)
Page 1 of 1