Elvas Tower: Somke exhaust moves to the rear - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Somke exhaust moves to the rear Rate Topic: -----

#1 User is offline   Rogue 

  • Hostler
  • Group: Status: Active Member
  • Posts: 98
  • Joined: 19-May 14
  • Gender:Male
  • Simulator:MSTS and Open Rails
  • Country:

Posted 21 September 2014 - 07:32 AM

Hi everyone,

one of the last builds must have changed the behaviour of the smoke exhaust of diesel engines.
The position of the smoke at the beginning is where it should be...over the defined exhaust pipe/position
But after driving a little it moves to the rear end of the train.
This happens with different locos and with coupled trains and solo locos.
Hope that this can be seen in the photos:

Attached Image: Open Rails 2014-09-21 05-12-38.png

Attached Image: Open Rails 2014-09-21 05-14-37.png

All the Best
Boris

#2 User is online   James Ross 

  • Open Rails Developer
  • Group: Status: Elite Member
  • Posts: 5,491
  • Joined: 30-June 10
  • Gender:Not Telling
  • Simulator:Open Rails
  • Country:

Posted 22 September 2014 - 02:16 AM

I had a suspicion that this might happen but couldn't make it occur myself. I'll try and correct this tonight.

#3 User is offline   gpz 

  • Superintendant
  • Group: Status: Elite Member
  • Posts: 1,772
  • Joined: 27-October 12
  • Gender:Male
  • Location:Budapest
  • Simulator:OpenRails
  • Country:

Posted 22 September 2014 - 08:28 AM

Reference thread: http://www.elvastowe...424#entry161424

#4 User is online   James Ross 

  • Open Rails Developer
  • Group: Status: Elite Member
  • Posts: 5,491
  • Joined: 30-June 10
  • Gender:Not Telling
  • Simulator:Open Rails
  • Country:

Posted 22 September 2014 - 12:34 PM

I think this should be fixed in X2511.

#5 User is offline   Rogue 

  • Hostler
  • Group: Status: Active Member
  • Posts: 98
  • Joined: 19-May 14
  • Gender:Male
  • Simulator:MSTS and Open Rails
  • Country:

Posted 24 September 2014 - 02:24 AM

 James Ross, on 22 September 2014 - 12:34 PM, said:

I think this should be fixed in X2511.


Looks good now...!
Thanks again.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users