Elvas Tower: Sander problems - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Sander problems Rate Topic: -----

#1 User is offline   engmod 

  • Open Rails Developer
  • PipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 1,774
  • Joined: 26-February 08
  • Gender:Male
  • Location:Eltham, Victoria, Australia
  • Simulator:ORNYMG
  • Country:

Posted 09 September 2014 - 08:43 PM

Is there any reason that my sanders are all blocked all of the time?

#2 User is offline   gpz 

  • Superintendant
  • Group: Status: Elite Member
  • Posts: 1,772
  • Joined: 27-October 12
  • Gender:Male
  • Location:Budapest
  • Simulator:OpenRails
  • Country:

Posted 09 September 2014 - 11:57 PM

What do you mean exactly? I modified the sander keyboard operation recently to match MSTS: relese key to off, shift to toggle.

#3 User is offline   engmod 

  • Open Rails Developer
  • PipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 1,774
  • Joined: 26-February 08
  • Gender:Male
  • Location:Eltham, Victoria, Australia
  • Simulator:ORNYMG
  • Country:

Posted 10 September 2014 - 02:23 AM

Hi Peter,

I have a message all the time when turning the sander on, it says "sander blocked"
It was happening before your change to sander button behaviour.

cheers

#4 User is offline   gpz 

  • Superintendant
  • Group: Status: Elite Member
  • Posts: 1,772
  • Joined: 27-October 12
  • Gender:Male
  • Location:Budapest
  • Simulator:OpenRails
  • Country:

Posted 10 September 2014 - 11:01 AM

As I can see in the code there is a "Sanding" maximum speed set in eng file's Engine() section. If locomotive speed exceeds the speed set here, the "Sander blocked" message will appear in HUD.

#5 User is offline   engmod 

  • Open Rails Developer
  • PipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 1,774
  • Joined: 26-February 08
  • Gender:Male
  • Location:Eltham, Victoria, Australia
  • Simulator:ORNYMG
  • Country:

Posted 10 September 2014 - 12:57 PM

Thanks Peter.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users