Playing shunting-type activities on the 3DTS Tehachapi route, I have several times encountered an odd situation where I am suddenly unable to move a relatively short train with a loco that was previously able to move the same wagons as part of a longer train. This usually happens after coupling. I check all the handbrakes and use Shift-; and connect and disconnect the airbrake hoses before using '/', but the train will not move in either direction. The only solution is to save the scenario and then reload the save file, at which point things are OK again.
Page 1 of 1
Suddenly unable to move train
#2
Posted 19 June 2014 - 07:45 PM
Keep in mind this is an Open Rails issue, which is still in development.
Page 1 of 1