Elvas Tower: Variable 1 Trigger - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Variable 1 Trigger Rate Topic: -----

#1 User is offline   alexmorph3us 

  • Hostler
  • Group: Status: Active Member
  • Posts: 62
  • Joined: 01-February 14
  • Simulator:MSTS
  • Country:

Posted 05 February 2014 - 04:33 PM

Hello.Is there any possibility for OpenRails to be able to read variable1 trigger commands in some sms script sounds when it comes to electric locos.For instance I'm using the sound of the ventilation to start automatically after a certain value of the throttle in MSTS and I wish OR could read that.Another thing is the Scalability Group 0 which is used for the AI traffic played sounds.Are these going to be implemented in the near future?

#2 User is offline   gpz 

  • Superintendant
  • Group: Status: Elite Member
  • Posts: 1,772
  • Joined: 27-October 12
  • Gender:Male
  • Location:Budapest
  • Simulator:OpenRails
  • Country:

Posted 05 February 2014 - 10:42 PM

Variable1 for electric locomotives in OpenRails is proportional to throttle controller, by using the following equation:
Variable1 = ThrottlePercent / 100f;

So it will be in range 0-1.

OpenRails uses the highest available scalability group for AI traffic too. This is different from MSTS.

#3 User is offline   alexmorph3us 

  • Hostler
  • Group: Status: Active Member
  • Posts: 62
  • Joined: 01-February 14
  • Simulator:MSTS
  • Country:

Posted 06 February 2014 - 11:38 AM

Thanks now it's working ;))

#4 User is offline   gpz 

  • Superintendant
  • Group: Status: Elite Member
  • Posts: 1,772
  • Joined: 27-October 12
  • Gender:Male
  • Location:Budapest
  • Simulator:OpenRails
  • Country:

Posted 06 February 2014 - 01:27 PM

You are welcome. ;)
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users