Log In
Register Now!
Help
Finally got the program of Open Rails running in my desktop but need one thing to change the speed limit posted from " KPH " to " MPH " in Track Monitor.
That's all I need to get this change and everything will run smoothly.
Smile,
John
Page 1 of 1
Speed Limit in Track Monitor
Rate Topic:
#1
- Conductor
-
- Group: Status: R.I.P. or just Retired
- Posts: 408
- Joined: 11-March 08
- Gender:Male
-
Country:
Posted 17 January 2014 - 06:53 AM
#2
- Foreman Of Engines
-
- Group: Status: Contributing Member
- Posts: 782
- Joined: 16-December 12
- Gender:Male
- Simulator:-
-
Country:
Posted 17 January 2014 - 06:56 AM
I believe that has to do with the route's speed configuration itself, not a problem with ORTS.
#3
- Conductor
-
- Group: Status: R.I.P. or just Retired
- Posts: 408
- Joined: 11-March 08
- Gender:Male
-
Country:
Posted 17 January 2014 - 07:08 AM
Oh really !! Well When I am in simulation with a Canadian route with an activity and the leading locomotive cab show me " MPH " but in Track Monitor show me in " KPH ". I find these confusing with two words that I am trying to keep the speed limit in the simulation. Anyway thanks for your time to reply.
John
John
PA1930, on 17 January 2014 - 06:56 AM, said:
I believe that has to do with the route's speed configuration itself, not a problem with ORTS.
#4
- Executive Vice President
-
- Group: Status: Elite Member
- Posts: 3,144
- Joined: 08-August 05
- Gender:Male
- Simulator:MSTS & OR
-
Country:
Posted 17 January 2014 - 07:23 AM
Check the route .trk file. If there is a line like this, MilepostUnitsKilometers ( ) change it to this, MilepostUnitsMiles ( ) and your cab speedometer units should then match the track monitor speed limit units.
#5
- Conductor
-
- Group: Status: R.I.P. or just Retired
- Posts: 408
- Joined: 11-March 08
- Gender:Male
-
Country:
Posted 17 January 2014 - 08:10 AM
Thank you for the trick and finally show " MPH " in Track Monitor now which match the locomotive cab show the same with " MPH ".
John
John
copperpen, on 17 January 2014 - 07:23 AM, said:
Check the route .trk file. If there is a line like this, MilepostUnitsKilometers ( ) change it to this, MilepostUnitsMiles ( ) and your cab speedometer units should then match the track monitor speed limit units.
#6
- Foreman Of Engines
-
- Group: Status: Contributing Member
- Posts: 782
- Joined: 16-December 12
- Gender:Male
- Simulator:-
-
Country:
Posted 17 January 2014 - 05:41 PM
copperpen, on 17 January 2014 - 07:23 AM, said:
Check the route .trk file. If there is a line like this, MilepostUnitsKilometers ( ) change it to this, MilepostUnitsMiles ( ) and your cab speedometer units should then match the track monitor speed limit units.
Thanks for your reply too, copperpen. I had the same issue with one route but didn't really bothered about it until now that you suggested that. :)
Page 1 of 1