Elvas Tower: TIR_500 vs Raildriver in Open Rails - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

TIR_500 vs Raildriver in Open Rails does not work Rate Topic: -----

#1 User is offline   R H Steele 

  • Executive Vice President
  • PipPipPipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 3,447
  • Joined: 14-March 13
  • Gender:Male
  • Location:known universe
  • Simulator:Open Rails
  • Country:

Posted 24 November 2013 - 12:29 AM

The TIR_500 engine will not work with Raildriver and Open Rails. Whenever I press the Raildriver run key, I get the "WSOD". At first I thought it was the Thousands Islands Railway, so I tried on another route, same problem. All other locomotives run fine, just the TIR_500. Works fine with keyboard controls. I thought maybe I could use RouteRiter to prep the engine for Raildriver, it has a function to do that, did not work. I've attached the OR log and the Eng file in case it could help. Any suggestions, anyone? Cheers, rhs (aka gerry)

Attached File(s)


#2 User is offline   engmod 

  • Open Rails Developer
  • PipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 1,781
  • Joined: 26-February 08
  • Gender:Male
  • Location:Eltham, Victoria, Australia
  • Simulator:ORNYMG
  • Country:

Posted 24 November 2013 - 03:32 AM

Take the 0. off the end of the throttle line.

Throttle ( 0 1 0.04 0.

cheers
Derek
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users