Log In
Register Now!
Help
Hi all,
I am trying to pick up some cars on the Full Bucket line. I have a six axel engine and can't get more than 2.5 mph with eng and train brakes released and no hand brakes on. I'm using OR v0.8.0.1251.
I can get no more than N3 on the power. If I go to N4 I get wheel-slip.
Any help will be greatly appreciated. Thanks.
Page 1 of 1
Under powered
Rate Topic:
#1
- Apprentice
-
- Group: Status: Inactive
- Posts: 36
- Joined: 15-August 12
- Gender:Male
- Location:Minnesota, USA
- Simulator:MSTS
-
Country:
Posted 30 May 2013 - 11:50 AM
#2
- Executive Vice President
-
- Group: Status: Elite Member
- Posts: 3,144
- Joined: 08-August 05
- Gender:Male
- Simulator:MSTS & OR
-
Country:
Posted 30 May 2013 - 11:52 AM
What engine are you using?. Also you might want to upgrade to a newer version of OR, X1615 is here http://openrails.org/experimental.html
#3
- Apprentice
-
- Group: Status: Inactive
- Posts: 36
- Joined: 15-August 12
- Gender:Male
- Location:Minnesota, USA
- Simulator:MSTS
-
Country:
Posted 30 May 2013 - 12:15 PM
I'm using NERR SD70M #9237
I installed x1625 and it didn't seem to make any difference. Now when I apply the emergency brake I can't get it to release.
I installed x1625 and it didn't seem to make any difference. Now when I apply the emergency brake I can't get it to release.
#4
- Executive Vice President
-
- Group: Status: Elite Member
- Posts: 3,144
- Joined: 08-August 05
- Gender:Male
- Simulator:MSTS & OR
-
Country:
Posted 30 May 2013 - 01:43 PM
Hoghead27, on 30 May 2013 - 12:15 PM, said:
I'm using NERR SD70M #9237
I installed x1625 and it didn't seem to make any difference. Now when I apply the emergency brake I can't get it to release.
I installed x1625 and it didn't seem to make any difference. Now when I apply the emergency brake I can't get it to release.
I have just run the #9237 all the way up to run 8 with no wheelslip. The emergency brake does release, but until the BC figure is at or near 0 the engine or train will not move. What are your FPS in OR?.
Page 1 of 1