[Lindsayts]

Is this a bug or am I missing something here. I have done an activty for the TA_VR_NE_1950s route representing the current 1632 pass from Southern Cross (Spencer st) station (Note 1) and OR will not register the final stop. The station concerned (Seymour platform 2) is correctly displayed as the next stop OR will not detect the stop no matter where one stops on the platform. All other stops are registered OK, even with only the rear of the train in the platform.

I have not registered this as a bug yet as I am unsure if it is one.

Note 1: Just in case, the activity is in fact theoretical as I have increased the power on the train, the 1632 being a loco hauled train the previous trains (1532 and earlier) being DMU's. The idea of the activity was to see of a push pull loco setup could match the DMU's time table (it can). I have found OR at this stage quite capable of simulating real life to a reasonable degree of accuracy.

LIndsay