Hello my name is Hector and I'm from Argentina, I comment the problem is the same as shown in the following Imaje
http://farm6.static.flickr.com/5175/5512097475_f33ebdf84a.jpg
This failure occurs when trying to use the model to make Genset locomotives, these are some pictures
http://farm5.static.flickr.com/4126/5432366064_c5931681b5.jpg http://farm6.static.flickr.com/5055/5432367196_e86da587ef.jpg
http://farm5.static.flickr.com/4143/5431757771_d0d54ab042.jpg http://farm6.static.flickr.com/5298/5431757353_93cce594f4.jpg
this model in MSTS does not work because it has 57389 polygons, the V360 openrails worked well, here the images
http://farm6.static.flickr.com/5092/5488225529_cb93640cf5.jpg http://farm6.static.flickr.com/5256/5488824276_ff2efd7e63.jpg http://farm6.static.flickr.com/5257/5488825202_ecdbe6ffde.jpg
http://farm6.static.flickr.com/5217/5488826278_d4c3b0815c.jpg http://farm6.static.flickr.com/5213/5488827494_d81f938957.jpg
but here the problem starts, without any reason openrails started to give me the error shown in the first picture shown, I can not fix it either going to use 360 of openrails vercion, I hope you can help me with this problem and sorry for my bad English.
greeting from The Argentina
Hector Rodolfo Jara
Page 1 of 1
3d model stops working Openrails (v360 and v646)
#2
Posted 11 March 2011 - 01:52 PM
57,389 polygons!!! :bigboss:
Talk about a poly monster...
Nice model, though.:lol2:
Can you send us the log file after the 'crash'?
:search:
Talk about a poly monster...
Nice model, though.:lol2:
Can you send us the log file after the 'crash'?
:search:
#3 Inactive_regis_*
Posted 11 March 2011 - 02:11 PM
here I leave the log file
Attached File(s)
-
OpenRailsLog.txt (4.56K)
Number of downloads: 276
#4
Posted 11 March 2011 - 04:01 PM
Hector. I have solved your problem (I think) Open Rails cannot find the cabview that your engine is looking for, ( i just replicated the error and logfile exactly on my PC, as well I ran successfully the rolling stock with the .CVF file in the right place. Double check the cabview line in the ENG file and make sure the CVF file exists.
Good luck
Good luck
#5
Posted 11 March 2011 - 04:08 PM
Nice work, Daniel. :search: Hope that fixes it for Hector.
:bigboss:
:bigboss:
#6 Inactive_regis_*
Posted 12 March 2011 - 10:56 AM
estimated Daniel:solves the problem, I worked for a week straight and could not solve it, I owe support to this model, you want a copy of that work just send me an MPcon a mail address so you sent him,
thanks again for the help
Hector jara
thanks again for the help
Hector jara
Page 1 of 1