Elvas Tower: Smoking Up A Storm! - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Smoking Up A Storm! Rate Topic: -----

#1 User is offline   flamex 

  • Engineer
  • Group: Status: Active Member
  • Posts: 667
  • Joined: 04-July 06
  • Gender:Male
  • Location:Ontario, Canada
  • Simulator:Open Rails / MSTS
  • Country:

Posted 11 November 2006 - 12:00 PM

Hmmm... I don't think the EPA would like this too much!
Attached Image: scrgrb2.jpg

Attached Image: scrgrb3.jpg

#2 Inactive_sstyrnol_*

  • Group: Status: Passengers (Obsolete)

Posted 12 November 2006 - 08:57 AM

Who cares about EPA? Railfans are who count... :p

Nice job on those steamers!

This post has been edited by sstyrnol: 12 November 2006 - 08:57 AM

#3 User is offline   timmuir 

  • Member since Nov. 2003
  • Group: Status: Elite Member
  • Posts: 9,528
  • Joined: 22-November 03
  • Gender:Not Telling
  • Location:Somewhere on the Beautiful Oregon Coast
  • Simulator:Open Rails Only
  • Country:

Posted 12 November 2006 - 11:24 AM

Man, that's a beauty, Philip! You're doing a great job on this project! Have you considered Marc Nelson's steam loco smoke mod? It adds more texture to it, here:
http://www.3dtrains....oads/misc.shtml

#4 User is offline   atsf37l 

  • Executive Vice President
  • Group: Status: First Class
  • Posts: 4,659
  • Joined: 25-February 05
  • Gender:Male
  • Location:San Diego
  • Simulator:ORTS
  • Country:

Posted 12 November 2006 - 05:46 PM

The good news is that there was no such thing as the EPA when those behemoths were running! :p

Gorgeous loco!

#5 User is offline   flamex 

  • Engineer
  • Group: Status: Active Member
  • Posts: 667
  • Joined: 04-July 06
  • Gender:Male
  • Location:Ontario, Canada
  • Simulator:Open Rails / MSTS
  • Country:

Posted 13 November 2006 - 09:01 AM

timmuir, on Nov 12 2006, 11:24 AM, said:

Man, that's a beauty, Philip! You're doing a great job on this project! Have you considered Marc Nelson's steam loco smoke mod? It adds more texture to it, here:
http://www.3dtrains....oads/misc.shtml

No, I haven't. I'll try it out later. I usually run only oil burners though, so the smoke here looks pretty realistic, other than the fact that there is so much of it. Usually properly fired oil burners don't produce so much smoke, except during sanding down, to remove mineral deposits in the flues.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users