Log In
Register Now!
Help
Hello again,
The relatively new EOT feature works nicely but I've found a case where EOTs cannot be removed after a train is "reversed" by a reverse point, instead clicking on the highlighted EOT in the EOT list window just gives the message "Player train already has a mounted EOT" and thus removing the existing EOT is impossible. This can make switching work effectively impossible if the player doesn't remove the EOT before reaching the reverse point in the path.
Additionally, there appears to be a bug that causes OR to crash if the player locomotive is disconnected while the EOT is still attached as well, haven't investigated that one yet.
Expected behavior: The EOT should always be possible to remove even if it's on the "front" of the train
Version: Recent unstable U2023.03.29-0851
Page 1 of 1
Unable to Remove EOT after Passing Reverse Point
Rate Topic:
#1
- Hostler
-
- Group: Status: Active Member
- Posts: 76
- Joined: 23-February 12
- Gender:Male
- Simulator:Open Rails
-
Country:
Posted 29 March 2023 - 04:56 PM
#2
- Member, Board of Directors
-
- Group: Status: Elite Member
- Posts: 7,016
- Joined: 31-December 11
- Gender:Male
-
Country:
Posted 30 March 2023 - 08:49 AM
Yes, I could reproduce both issues and will try to solve them.
#3
- Member, Board of Directors
-
- Group: Status: Elite Member
- Posts: 7,016
- Joined: 31-December 11
- Gender:Male
-
Country:
Posted 31 March 2023 - 11:59 AM
The crash after player locomotive uncoupling is now fixed in ORNYMG 140.2 and in Unstable U2023.03.31-1821.
#4
- Member, Board of Directors
-
- Group: Status: Elite Member
- Posts: 7,016
- Joined: 31-December 11
- Gender:Male
-
Country:
Posted 02 April 2023 - 08:37 AM
EOT can now be dismounted after a reversal in ORNYMG 140.3 as well in the Unstable release that should be available in about half an hour after the time of this post.
Page 1 of 1