Elvas Tower: Pantograph is shown once as 1 and then as 4 - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Pantograph is shown once as 1 and then as 4 Rate Topic: -----

#1 User is offline   jonas 

  • Engineer
  • Group: Status: Contributing Member
  • Posts: 548
  • Joined: 04-April 14
  • Gender:Male
  • Simulator:MSTS & OR
  • Country:

Posted 04 September 2021 - 10:44 AM

Hi,

When I run the japanese train "Series 2000" from original MSTS and switch the pathograph with the p key, I get alternately the following message:

Panthograph 4: raise

and

Panthograph 1: lower

Viewed with current OR version U2021.09.04-0106.

Jonas

#2 User is offline   Csantucci 

  • Member, Board of Directors
  • Group: Status: Elite Member
  • Posts: 7,000
  • Joined: 31-December 11
  • Gender:Male
  • Country:

Posted 04 September 2021 - 12:18 PM

Yes, this has already been reported here http://www.elvastowe...-4-is-reported/ .

#3 User is offline   jonas 

  • Engineer
  • Group: Status: Contributing Member
  • Posts: 548
  • Joined: 04-April 14
  • Gender:Male
  • Simulator:MSTS & OR
  • Country:

Posted 05 September 2021 - 02:50 AM

 Csantucci, on 04 September 2021 - 12:18 PM, said:

Yes, this has already been reported here http://www.elvastowe...-4-is-reported/ .


Thanks for the awareness, I did not know this thread.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users