Elvas Tower: Analogue Clock In 2d Cabview? - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Analogue Clock In 2d Cabview? Rate Topic: -----

#1 User is offline   Batuka 

  • Apprentice
  • Group: Status: Dispatcher
  • Posts: 14
  • Joined: 22-August 18
  • Gender:Male
  • Simulator:MSTS
  • Country:

Posted 29 May 2021 - 04:02 AM

In find in Documentation (https://git.launchpa...283a008068f7cd1)
few CABViewControlTypes:
ORTS_HOURDIAL,
ORTS_MINUTEDIAL,
ORTS_SECONDDIAL

My Question: This types Aviable in current OR version? If yes, then please add the sample how to work?

#2 User is offline   roeter 

  • Vice President
  • Group: Status: Elite Member
  • Posts: 2,420
  • Joined: 25-October 11
  • Gender:Male
  • Country:

Posted 29 May 2021 - 04:06 AM

                DialClock (
			Hours (
				Position ( 191 286 1 22 )
				Pivot ( 3 )
				Graphic ( "../../../Cabs/Diesel/CAB_DB_628/628-hour.ace" )
			)
			Minutes (
				Position ( 191 286 1 30 )
				Pivot ( 3 )
				Graphic ( "../../../Cabs/Diesel/CAB_DB_628/628-minute.ace" )
			)
			Seconds (
				Position ( 191 286 1 30 )
				Pivot ( 3 )
				Graphic ( "../../../Cabs/Diesel/CAB_DB_628/628-second.ace" )
			)
		)


Regards,
Rob Roeterdink

#3 User is offline   Batuka 

  • Apprentice
  • Group: Status: Dispatcher
  • Posts: 14
  • Joined: 22-August 18
  • Gender:Male
  • Simulator:MSTS
  • Country:

Posted 29 May 2021 - 04:22 AM

Thanks!

#4 User is offline   jan111 

  • Fireman
  • Group: Status: Active Member
  • Posts: 122
  • Joined: 11-November 13
  • Gender:Male
  • Location:Copenhagen
  • Simulator:OpenRails & MSTS
  • Country:

Posted 29 May 2023 - 01:15 PM

Even if its old i just stumbled over this topic and I would love analogue clock in some my old train but have do I install, especialy how to get the correct graphics

#5 User is offline   Weter 

  • Member, Board of Directors
  • PipPipPipPipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 6,806
  • Joined: 01-June 20
  • Gender:Not Telling
  • Simulator:ORTS
  • Country:

Posted 29 May 2023 - 01:48 PM

Hello.
Cut needles from cab image, make *.tga-files, where everything, but needle itself is alphaed-out, convert it to *.ace and use, properly defined the name, size and pivot point.
This is in one phrase.

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users