Good afternoon,
I am creating an Italian diesel loco (picture here ) and I'm having troubles writing a correct eng file:
I used some parts of the eng files available for testing on coalstonewcastle.com.au and I came up with this.
For some reason though, when I test it, the loco doesn't move at all.
I'm asking your help since I cannot find which parameters are wrong or missing.
Thank you.
ps.
Some parts of the eng file are still WIP, like the lights or the exhaust. I didn't mention it before because I'm assuming they don't interact with the parts that may be causing problems.
Page 1 of 1
eng file parameters issue
#2
Posted 13 May 2021 - 06:34 AM
torri91, on 13 May 2021 - 05:16 AM, said:
Good afternoon,
I am creating an Italian diesel loco (picture here ) and I'm having troubles writing a correct eng file:
I used some parts of the eng files available for testing on coalstonewcastle.com.au and I came up with this.
For some reason though, when I test it, the loco doesn't move at all.
I'm asking your help since I cannot find which parameters are wrong or missing.
Thank you.
ps.
Some parts of the eng file are still WIP, like the lights or the exhaust. I didn't mention it before because I'm assuming they don't interact with the parts that may be causing problems.
I am creating an Italian diesel loco (picture here ) and I'm having troubles writing a correct eng file:
I used some parts of the eng files available for testing on coalstonewcastle.com.au and I came up with this.
For some reason though, when I test it, the loco doesn't move at all.
I'm asking your help since I cannot find which parameters are wrong or missing.
Thank you.
ps.
Some parts of the eng file are still WIP, like the lights or the exhaust. I didn't mention it before because I'm assuming they don't interact with the parts that may be causing problems.
ORTSBearingType ( Roller ) ORTSDavis_A ( 89,526 ) ORTSDavis_B ( 0,7275 ) ORTSDavis_C ( 0,2336 )
OR will read that at 89526. Train might as well be cemented to the track!
Try this!
ORTSBearingType ( Roller ) ORTSDavis_A ( 89.526 ) ORTSDavis_B ( 0.7275 ) ORTSDavis_C ( 0.2336 )
Unless there are any other errors, the train should move.
Thanks
#3
Posted 13 May 2021 - 09:54 AM
Also, if you calculated the ORTS Davis values to units other than the defaults specified by OR --- those units must be placed immediately following the values ( no space between unit and Davis number )
See manual - Steam Engine Section 8.4 page 99 ( under Friction - Wagon Section ) for default and recommended ORTS Davis units
See manual - Steam Engine Section 8.4 page 99 ( under Friction - Wagon Section ) for default and recommended ORTS Davis units
#4
Posted 13 May 2021 - 10:56 AM
I copied the values directly from the fcalc excel file without checking which separator was used. I should have been more careful.
Thank you!
Thank you!
Page 1 of 1