Log In
Register Now!
Help
This post has been edited by emsob: 02 March 2021 - 01:43 AM
Page 1 of 1
Cabview file
Rate Topic:
#1
- Apprentice
-
- Group: Status: Switchman
- Posts: 9
- Joined: 09-August 20
- Gender:Male
- Simulator:Open Rails
-
Country:
Posted 02 March 2021 - 01:34 AM
I am preparing my first cabin and I have a question. Can both pantographs be raised using different buttons in the cabin? So far, looking at the cabviews, I can see that there is a button to raising one pantograph, and the other one has to be raised with a on keyboard.
#2
- Member, Board of Directors
-
- Group: ET Admin
- Posts: 6,888
- Joined: 01-June 20
- Gender:Not Telling
- Simulator:ORTS
-
Country:
Posted 02 March 2021 - 06:24 AM
Welcome to here.
I suggest to find MSTS Bin manual, as it has pictures of controls, available to handle pantographs, and explanations.
Its Author was czech (George Vansa), so that ideas probably will be suitable for polish locos.
If you can't, I maybe will send it here, but only at weekend.
Also, look for topic about 4 panto control here - at ET forums.
Good luck.
I suggest to find MSTS Bin manual, as it has pictures of controls, available to handle pantographs, and explanations.
Its Author was czech (George Vansa), so that ideas probably will be suitable for polish locos.
If you can't, I maybe will send it here, but only at weekend.
Also, look for topic about 4 panto control here - at ET forums.
Good luck.
#3
- Apprentice
-
- Group: Status: Switchman
- Posts: 9
- Joined: 09-August 20
- Gender:Male
- Simulator:Open Rails
-
Country:
Posted 04 March 2021 - 02:34 AM
Thank you very much, I solved my problem using: "PANTOGRAPH2 TWO_STATE". I have a problem finding this manual. I found similar but it wasn't what I was looking for. If possible, please send it.
#4
- Member, Board of Directors
-
- Group: ET Admin
- Posts: 6,888
- Joined: 01-June 20
- Gender:Not Telling
- Simulator:ORTS
-
Country:
Posted 04 March 2021 - 12:14 PM
Page 1 of 1