Quick Question - New model doesn't appear How does OR determine this?
#1
Posted 25 December 2020 - 10:38 AM
I just completed a new locomotive model, and assigned the shape to a working eng file. I built a consist in TSRE Conbuilder, but the unit does not appear in OR when I start it up.
There was nothing in the log file. What would prevent OR from loading a consist (single loco)?
Thanks
Rick
#2
Posted 25 December 2020 - 12:23 PM
Does the model open in Shape Viewer? Shape Fixer or Route Riter?
regards,
vince
#3
Posted 25 December 2020 - 12:36 PM
#4
Posted 25 December 2020 - 01:42 PM
Doug
#5
Posted 25 December 2020 - 03:32 PM
dajones, on 25 December 2020 - 01:42 PM, said:
Doug
I'll check, Doug, but I think I did a global replace.
#6
Posted 25 December 2020 - 06:53 PM
Installing in Program Files, Program Files (86) and User folders. This results is CON files not being saved to Consists folder.
The case of the filename, the two Wagon lines and the Engine line must match.
No cabview for lead loco.
#7
Posted 25 December 2020 - 07:13 PM
cr-stagg, on 25 December 2020 - 06:53 PM, said:
Installing in Program Files, Program Files (86) and User folders. This results is CON files not being saved to Consists folder.
The case of the filename, the two Wagon lines and the Engine line must match.
No cabview for lead loco.
1) installed in C:\1MSTS
2) all lines match
3) there is a cabview for the lead loco
Charles, I'm totally stumped.
Rick
#8
Posted 25 December 2020 - 07:15 PM
rfranzosa, on 25 December 2020 - 07:13 PM, said:
2) all lines match
3) there is a cabview for the lead loco
Charles, I'm totally stumped.
Rick
Post the ENG file so I can d/l and test it.
BTW You said you used TSRE Conbuilder to create the consist. Did you use the TSRE Consist Editor or ConBuilder?
#9
Posted 25 December 2020 - 08:57 PM
cr-stagg, on 25 December 2020 - 07:15 PM, said:
BTW You said you used TSRE Conbuilder to create the consist. Did you use the TSRE Consist Editor or ConBuilder?
I was using TSRE Con Editor.
I started over from scratch. I took a working eng file, edited it for the new model, and created a new consist in TSRE con editor. This time it worked. Not sure where the problem was, I probably skipped a step at some point.
Thanks!
Rick
#10
Posted 25 December 2020 - 10:41 PM
rfranzosa, on 25 December 2020 - 08:57 PM, said:
I started over from scratch. I took a working eng file, edited it for the new model, and created a new consist in TSRE con editor. This time it worked. Not sure where the problem was, I probably skipped a step at some point.
Thanks!
Rick