Elvas Tower: Cabview digital displays - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Cabview digital displays Rate Topic: -----

#1 User is offline   hugoakio 

  • Hostler
  • PipPip
  • Group: Status: Fired
  • Posts: 51
  • Joined: 28-February 19
  • Gender:Male
  • Simulator:Open rails
  • Country:

Posted 13 December 2020 - 04:00 PM

I'm trying to make a locomotive monitor for a Dash 9 (like the photo attached) with the majority of parameters working.

There's any list of the "digital displays" that I can use in the .cvf file? I'm looking for some "hide" or unknown parameters, like some command to show the "ThrottleRPM", "DieselPower", "load %" or some kind of temperature?

Thank you!

Attached thumbnail(s)

  • Attached Image: Sem título.jpg

#2 User is offline   Weter 

  • Member, Board of Directors
  • PipPipPipPipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 6,926
  • Joined: 01-June 20
  • Gender:Not Telling
  • Simulator:ORTS
  • Country:

Posted 13 December 2020 - 06:04 PM

1. There is Rudolf Richter's ENG-Manual document, that describes many parameters, discovered by author.
I think, it was Steam4me Australian website.
2. Cjakeman mentioned somewhere here the table of some author, that lists many ORTS Eng-parameters.
3. Watch here, as CesarBl programs new displays for cabs.

#3 User is offline   cjakeman 

  • Vice President
  • PipPipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 2,867
  • Joined: 03-May 11
  • Gender:Male
  • Location:Peterborough, UK
  • Simulator:Open Rails
  • Country:

Posted 14 December 2020 - 05:33 AM

 Weter, on 13 December 2020 - 06:04 PM, said:

2. Cjakeman mentioned somewhere here the table of some author, that lists many ORTS Eng-parameters.
The author is RR1

#4 User is offline   hugoakio 

  • Hostler
  • PipPip
  • Group: Status: Fired
  • Posts: 51
  • Joined: 28-February 19
  • Gender:Male
  • Simulator:Open rails
  • Country:

Posted 14 December 2020 - 08:27 AM

Thank you very much! It's exactly what i'm looking for.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users