Elvas Tower: Problem displaying dynamic load - Elvas Tower

Jump to content

  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

Problem displaying dynamic load Rate Topic: -----

#11 User is offline   Csantucci 

  • Member, Board of Directors
  • Group: Status: Elite Member
  • Posts: 7,000
  • Joined: 31-December 11
  • Gender:Male
  • Country:

Posted 24 August 2020 - 10:59 AM

OK, I get the problem with coal.

#12 User is offline   Csantucci 

  • Member, Board of Directors
  • Group: Status: Elite Member
  • Posts: 7,000
  • Joined: 31-December 11
  • Gender:Male
  • Country:

Posted 24 August 2020 - 11:53 AM

It's not a problem of OR, it's a problem of the .s file of the load. uhli1.s has an animation defined. This animation didn't work when OR didn't accept a line like this one
animation ( 1 30

with the first number = 1. After this bug correction http://www.elvastowe...or/page__st__10 OR accepts the above line and therefore continuously animates the load. However the load must not be animated: the motion up and down depending from the amount of the load is directly controlled by OR and does not require an animation. So that animation must be removed from the uhli1.s file and from analogous load shape files.

#13 User is offline   Lamplighter 

  • Fireman
  • Group: Status: Active Member
  • Posts: 171
  • Joined: 24-January 18
  • Gender:Male
  • Simulator:Open Rails
  • Country:

Posted 24 August 2020 - 12:20 PM

On the one hand, I'm glad a mistake was found. On the other hand - before fixing the 7.6.2020 bug there was no problem.
But thank you anyway. I'll just have to fix a lot of loads .s :(
In other words: the problem with the escalator was solved, but there was a problem with the animated load ...
  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users