Elvas Tower: $hold not effective in passing paths - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

$hold not effective in passing paths Rate Topic: -----

#1 User is offline   Gro.Bi 

  • Fireman
  • Group: Status: Active Member
  • Posts: 105
  • Joined: 13-May 15
  • Simulator:Open Rails
  • Country:

Posted 20 June 2020 - 11:19 AM

In timetable mode it seems that the $hold command is not effective if the relevant train is on a passing path during its station stop.
In such situation the exit signal of the platform is not held. If the train is on a passing path and has a scheduled stop of several minutes in that station, the further path is already reserved since its arrival time so that other trains are prevented from leaving or arriving at the station.
I made this observation on Open Rails 1.3.1 and X1.3.1-152-gc6043616 (not sure if this situation occured in previous versions).

Is it a bug or is it intended that $hold is not valid on passing paths?

Regards,
Gro.Bi
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users