Elvas Tower: Problem with dynamic nums display in cabview - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Problem with dynamic nums display in cabview OR Stable ver1.3 and OR MG Rev59 Rate Topic: -----

#1 User is offline   R H Steele 

  • Executive Vice President
  • PipPipPipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 3,439
  • Joined: 14-March 13
  • Gender:Male
  • Location:known universe
  • Simulator:Open Rails
  • Country:

Posted 09 May 2020 - 02:28 PM

I've got a problem with a dynamic nums display in an SLI cabview. I know very little about cabviews. I've been trying to figure this out and am completely baffled. Every solution I've tried does not work --- I won't go through them all, instead I took a bunch of screenshots to show what is going on.

The display shows "2" when they dynamics are off --- at 60% ( by the "Train Driving Window" in OR ) they show "8". I don't know if this a problem with OR, the cvf, or the design of the cabview. SLI SP ENGINES folder >>> SP_SD70M_9803.eng SD75M.cvf.
Appears the problem is with OR, display behaves differently but still incorrectly in both OR last stable ver 1.3 and recent MG Rev59 Any help appreciated. Gerry

Please see this thread at TrainSim.com --- Dynamic Nums Display

Detailed screenshots attached

Attached File(s)


#2 User is offline   R H Steele 

  • Executive Vice President
  • PipPipPipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 3,439
  • Joined: 14-March 13
  • Gender:Male
  • Location:known universe
  • Simulator:Open Rails
  • Country:

Posted 10 May 2020 - 10:22 AM

Problem solved, if interested please use thread link post#1. Gerry
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users