Elvas Tower: Moving starting point of a path - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Moving starting point of a path Rate Topic: -----

#1 User is offline   Hannes44 

  • Fireman
  • Group: Status: Active Member
  • Posts: 161
  • Joined: 10-October 17
  • Gender:Male
  • Location:Select State/Province
  • Simulator:Open Rails
  • Country:

Posted 30 December 2019 - 06:31 AM

Is there some way to move the starting point of a path further back, without doing the whole path all over again?

#2 User is offline   Hobo 

  • Foreman Of Engines
  • Group: Status: Contributing Member
  • Posts: 968
  • Joined: 19-December 04
  • Gender:Male
  • Location:Paris,Ont- Canada
  • Simulator:OPEN RAILS & MSTS
  • Country:

Posted 30 December 2019 - 07:54 AM

Track Viewer lets you edit paths . Not sure about the activities involved in that path . They might not be too happy about the change .

#3 User is offline   Hannes44 

  • Fireman
  • Group: Status: Active Member
  • Posts: 161
  • Joined: 10-October 17
  • Gender:Male
  • Location:Select State/Province
  • Simulator:Open Rails
  • Country:

Posted 30 December 2019 - 10:02 AM

I only use timetables, no problem with activities for me. I know how to edit paths, but didn't find a possibility to move the starting-point.

#4 User is offline   MMax 

  • Apprentice
  • Group: Status: Dispatcher
  • Posts: 35
  • Joined: 04-December 19
  • Gender:Male
  • Simulator:Open Rails
  • Country:

Posted 30 December 2019 - 02:10 PM

I think you can right-klick on the track after the first node and select "cut path here and store its tail". Then, you can delete/move the starting point and go "reconnect to tail". Your path shouldn't have changed except your own changes.

#5 User is offline   Hannes44 

  • Fireman
  • Group: Status: Active Member
  • Posts: 161
  • Joined: 10-October 17
  • Gender:Male
  • Location:Select State/Province
  • Simulator:Open Rails
  • Country:

Posted 31 December 2019 - 03:14 PM

View PostMMax, on 30 December 2019 - 02:10 PM, said:

I think you can right-klick on the track after the first node and select "cut path here and store its tail". Then, you can delete/move the starting point and go "reconnect to tail". Your path shouldn't have changed except your own changes.

Thank you, that worked!

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users