Elvas Tower: Render process is hung - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Render process is hung Rate Topic: -----

#1 User is offline   motor1 

  • Vice President
  • Group: Status: Elite Member
  • Posts: 2,875
  • Joined: 21-December 14
  • Gender:Male
  • Location:Northeast Oregon
  • Simulator:Microsoft Train Simulator
  • Country:

Posted 03 May 2019 - 06:39 PM

For the last couple days, I try to run a D&RGW narrow gauge train with gondolas on Marshall pass on the 2019 version of Don's monster route; when I switch to the exterior view, the screen freezes, then the game closes. I look at the log, & it shows the render has hung. Here is a log.

Attached File(s)


#2 User is offline   Csantucci 

  • Member, Board of Directors
  • Group: Status: Elite Member
  • Posts: 6,996
  • Joined: 31-December 11
  • Gender:Male
  • Country:

Posted 03 May 2019 - 11:10 PM

I believe that this is due to your computer being not so performant.
Try unchecking experimental option "Automatically tune settings to keep performance level". If the problem persists, use the OR NewYear MG version (see here http://www.elvastowe...post__p__247333 ) and uncheck general option "Watchdog".
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users