Elvas Tower: TRACTION and BRAKING Cabcontrol - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

TRACTION and BRAKING Cabcontrol Rate Topic: -----

#1 User is offline   Genma Saotome 

  • Owner Emeritus and Admin
  • PipPipPipPipPipPipPipPipPipPipPipPipPip
  • Group: ET Admin
  • Posts: 15,341
  • Joined: 11-January 04
  • Gender:Male
  • Location:United States
  • Simulator:Open Rails
  • Country:

Posted 10 March 2019 - 12:44 PM

DO NOT WRITE ANY POSTS OR PM's until you see an all clear announcement.


Please EXIT the board software IMMEDIATELY

#2 User is offline   IndraSkar 

  • Apprentice
  • Group: Status: Switchman
  • Posts: 17
  • Joined: 09-April 18
  • Gender:Male
  • Simulator:Openrail
  • Country:

Posted 01 April 2019 - 10:27 AM

Hi...
I have introduced a TRACTION_BRAKING cabcontrol in my EMD loco cabview, in traction mode its works very fine but while dynamic braking the needle also deflecting right side instead of its true position (left side); how do i overcome this problem?

Dial (
Type ( TRACTION_BRAKING DIAL )
Position ( 338 247 6 25 )
Graphic ( "EMD-TEBE-Needle-Pvt170.ace" )
Style ( POINTER )
ScaleRange ( -300 550 )
ScalePos ( 277 152 )
Units ( KILO_NEWTONS )
Pivot ( 17 )
DirIncrease ( 0 )
)
video link-
https://youtu.be/kDn3PcLTaM0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users