So I have tune a little brakes settings in polish locos and I have problem. I type in correct(?) parametters and I can't get propper brake cylinder pressure. Brake line and rest is correct 0.5 KPa od 5 bar but brake cylinder I.n normal braking mode should work to 0.42KPa and in emergency mode 0.62 KPa. I can't get those numbers in F5 display during simulation. Can You check eng file for me and tell me what is the problem ? Below is photo of brake cylinder manometer from polish locomotive with marked pressures for 100% in normal and 6.25 in emergrgency. Loco in att.
https://zapodaj.net/images/f10bdaa911039.jpg
Page 1 of 1
What I'm doing wrong ?
Page 1 of 1