[Csantucci]

I have seen that there are some trainset cabviews that have the DYNAMIC_BRAKE_FORCE dial, that OR does not recognize. Is it a keyword recognized by MSTS?

[Coolhand101]

Csantucci, on 18 September 2018 - 04:55 AM, said:

I have seen that there are some trainset cabviews that have the DYNAMIC_BRAKE_FORCE dial, that OR does not recognize. Is it a keyword recognized by MSTS?

Yes, on some of my old MSTS cabs, i have this. MSTS did recognized this token as below:

Dial (
			Type ( DYNAMIC_BRAKE_FORCE DIAL )
			Position ( 371 337 17 42 )
			Graphic ( "..\\..\\MT_GP_common.cab\\Class_400\\411-Brake-Cyl-Needle.ace" )
			Style ( NEEDLE )
			ScaleRange ( 0 46000 )
			ScalePos ( 223 350 )
			Units ( NEWTONS )
			Pivot ( 26 )
			DirIncrease ( 0 )
		)

I'm unsure if this was included with MSTS or added later by MSTSBin. However MSTS does recognize and correctly display this dial.

In OR, the log always reports this as an unrecognized cab display entry!

Thanks

[Csantucci]

Thank you. Dial added in x.4210.

[Stijn D.C.]

We need a KiloNewtons needle that give traction and (dynamic)brakeforce too.

Normal in MSTS & ORTS there is a Traction/Braking needle, if i give this -120 120 and KiloNewtons in scalerange, it works only in positive area, negtive not.

It must be work like AMMETER, this works well in negative and postive direction.

A fix that traction/braking works in negative direction too and KiloNewtons and this is be ok.