Elvas Tower: Signalling End-of-Command - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Signalling End-of-Command

#1 User is offline   WaltN 

  • Open Rails Developer
  • Group: Elite Member
  • Posts: 1,054
  • Joined: 28-February 10
  • Gender:Male
  • Location:Vestal, New York
  • Simulator:Open Rails, MSTS
  • Country:

Posted 09 June 2018 - 07:30 AM

I'm back at it -- editing -- after a long absence, and I have a question.

While editing, say relocating a forest, I select the forest, hit T to translate it. When I have it where I want it, what do I hit to signal that I want to end that command and go on to something else, say move another forest?

#2 User is offline   ebnertra000 

  • Conductor
  • Group: Active Member
  • Posts: 347
  • Joined: 27-February 17
  • Gender:Male
  • Location:East-Central Minnesota
  • Simulator:OR/TSRE
  • Country:

Posted 09 June 2018 - 08:26 AM

I assume you're talking about TSRE? If so, two things:

I didn't know there was a 'translate' command using the T key, and

Try pressing E and then clicking on the sky or something. That probably will do it for you

#3 User is online   Goku 

  • Superintendant
  • Group: Elite Member
  • Posts: 1,570
  • Joined: 12-December 13
  • Gender:Male
  • Simulator:my own
  • Country:

Posted 09 June 2018 - 08:27 AM

You can just go back to select mode E.
For simple translations you do not need to go into T mode. Just drag selected object in E mode.

#4 User is offline   WaltN 

  • Open Rails Developer
  • Group: Elite Member
  • Posts: 1,054
  • Joined: 28-February 10
  • Gender:Male
  • Location:Vestal, New York
  • Simulator:Open Rails, MSTS
  • Country:

Posted 10 June 2018 - 09:39 AM

Thank you, gentlemen, for your clarification. I've got the hang of it now.

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users