Hi
After a long break, i've jumped into OR content development, so i'm trying to upgrade my timetable for the current newer version of the route, which works without problem, except one signal which i stays red forever, while the path is clear, and i can solve the problem only by manually setting it to proceed.
So i want to find out what's te problem, but i can't find the signal debug mode in manual. How can i enable it? That thing that shows the occuppied segments and signal infos visually in the 3D view.
Page 1 of 1
Signal debug view
#3
Posted 21 March 2018 - 03:29 PM
Csantucci, on 18 March 2018 - 12:47 PM, said:
Ctrl-Alt-F11
An other possibility is using the dispatcher-Window:
1. activate the option Dispatcher-Window
2. Start the activity
3. Press CTRL+9
4. Press and hold alt press TAB as many until the dispatchViewer is marked and release the key's.
In this window you see all active trains,
and you can control if the track behind your Problem-Signal is really free.
Other possibility is HUD F5 + 5 times Shift+F5
Dispatcher information You can control the path's for all active Trains
the code for "path" you will find in the Manual Chapter 7.17.5
regards
EugenR
Page 1 of 1