Elvas Tower: Setting max speed for trains in timetable - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Setting max speed for trains in timetable I can't figure out how to use the #speedmph command Rate Topic: -----

#1 User is offline   markyisri 

  • Apprentice
  • Group: Status: Dispatcher
  • Posts: 27
  • Joined: 10-November 17
  • Gender:Male
  • Simulator:Open Rails
  • Country:

Posted 13 November 2017 - 07:40 AM

I made a row and labelled it #speedmph. Under each train, in that row, I put "#max 70", as TimetableChanges.pdf instructs, thus telling that train to not move faster than 70 mph.

However, when I go to drive the train, it didn't seem to have any speed limit imposed on it by that command at all. It could go all the way to 82 mph (the maximum velocity set in the .eng file).

What did I do wrong? (I also tried "#max=70" which didn't work either.)

#2 User is offline   roeter 

  • Vice President
  • Group: Status: Elite Member
  • Posts: 2,419
  • Joined: 25-October 11
  • Gender:Male
  • Country:

Posted 13 November 2017 - 08:34 AM

It should be $max=70.

Regards,
Rob Roeterdink

#3 User is offline   markyisri 

  • Apprentice
  • Group: Status: Dispatcher
  • Posts: 27
  • Joined: 10-November 17
  • Gender:Male
  • Simulator:Open Rails
  • Country:

Posted 13 November 2017 - 04:34 PM

View Postroeter, on 13 November 2017 - 08:34 AM, said:

It should be $max=70.

Regards,
Rob Roeterdink


Thanks Rob. That fixed it.

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users