Elvas Tower: Trains in MSTS-Standardroute Europa2 can never start, . - Elvas Tower

Jump to content

  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

Trains in MSTS-Standardroute Europa2 can never start, . the brakes are wrong initialised Rate Topic: -----

#11 User is offline   copperpen 

  • Executive Vice President
  • Group: Status: Elite Member
  • Posts: 3,143
  • Joined: 08-August 05
  • Gender:Male
  • Simulator:MSTS & OR
  • Country:

Posted 19 November 2017 - 07:38 AM

View PostCsantucci, on 19 November 2017 - 06:39 AM, said:

Hi Merwyn,
in fact you modified the whole Brake_Train block, so that your initial value (0.25) corresponds to the TrainBrakesControllerRunningStart position, which does not discharge the brake pipe. Instead in the default .eng file the initial value is 0.6, which is in the Apply zone.


I changed my loco and train brakes to be applied at the start of an activity or explore route. Now, in both activity and explore modes the triple valve shows Emergency. On releasing the brakes the triple valve shows as Lap, but brake force is zero.

#12 User is offline   eugenR 

  • Conductor
  • Group: Status: Contributing Member
  • Posts: 472
  • Joined: 15-April 13
  • Gender:Male
  • Simulator:MSTS
  • Country:

Posted 19 November 2017 - 08:29 AM

Sorry I have forgotten to post the original 380.eng-file from 1.6.2001
Eugen

Attached File(s)

  • Attached File  380.zip (5.43K)
    Number of downloads: 193

#13 User is offline   Csantucci 

  • Member, Board of Directors
  • Group: Status: Elite Member
  • Posts: 6,996
  • Joined: 31-December 11
  • Gender:Male
  • Country:

Posted 20 November 2017 - 12:29 PM

Fixed in x.3984. Thanks to Eugen for suggestions and for testing.

#14 User is offline   eugenR 

  • Conductor
  • Group: Status: Contributing Member
  • Posts: 472
  • Joined: 15-April 13
  • Gender:Male
  • Simulator:MSTS
  • Country:

Posted 21 November 2017 - 07:11 AM

View PostCsantucci, on 20 November 2017 - 12:29 PM, said:

Fixed in x.3984. Thanks to Eugen for suggestions and for testing.


Hi Carlo,
I have tested X3987, I think, now all this pressures are now correct initialised.
Thank You for fixing.

EugenR
  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users