Elvas Tower: AI does not want to move - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

AI does not want to move Rate Topic: -----

#1 User is offline   Icik 

  • Conductor
  • Group: Status: Active Member
  • Posts: 308
  • Joined: 19-April 15
  • Simulator:Open Rails
  • Country:

Posted 25 September 2017 - 09:40 AM

Hello to everybody,

do not you know why the AI ​​train "7P" against the restriction signal stands in place and does not want to go out? The route is OK.

Here video ...

https://www.youtube....eature=youtu.be

#2 User is offline   Csantucci 

  • Member, Board of Directors
  • Group: Status: Elite Member
  • Posts: 7,000
  • Joined: 31-December 11
  • Gender:Male
  • Country:

Posted 27 September 2017 - 10:18 PM

To analyse this I should have the links to download route, activity, trainset. A screenshot with the dispatcher window is also useful.

#3 User is offline   roeter 

  • Vice President
  • Group: Status: Elite Member
  • Posts: 2,424
  • Joined: 25-October 11
  • Gender:Male
  • Country:

Posted 28 September 2017 - 02:56 AM

The display isn't very clear, but from what I can see it looks like an interaction between the signal and a waiting point.
Is there a waiting point defined just beyond the signal or something like that?

Regards,
Rob Roeterdink

#4 User is offline   Icik 

  • Conductor
  • Group: Status: Active Member
  • Posts: 308
  • Joined: 19-April 15
  • Simulator:Open Rails
  • Country:

Posted 28 September 2017 - 04:49 AM

I checked the set path of this AI and found that it had 2 reversed points defined at the endpoint. After removing these points, AI will normally go through. If I redefined the points again, AI does not have a problem again and the route passes. Apparently an invisible error in the original route setting.
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users