Help with Reset Button

Help with Reset Button Rate Topic:

#1 elkwharton

Apprentice

Group: Status: Switchman
Posts: 19
Joined: 09-July 14
Gender:Male
Simulator:OPEN RAILS
Country:

Posted 15 August 2017 - 05:58 AM

Hi Folks,

Sorry for all the posts, but am fairly new to OR and its programming. I am trying to set what in msts was the reset button to cancel the alerter. I have set it up the same as all my other two state controls which work, however when I hit the Z key to cancel the alerter nothing happens. The animations are correct and work in the 3d program, and the proper entries are in the .cvf file. The part is named Reset:0:0 . Does anyone have any Ideas why this isn't working or is Reset only associated with faults in OR.

Thanks for any help
Jeff

#2 Csantucci

Member, Board of Directors

Group: Status: Elite Member
Posts: 6,996
Joined: 31-December 11
Gender:Male
Country:

Posted 15 August 2017 - 06:50 AM

Does the alerter reset control work with 2D cabs in your engine?

#3 elkwharton

Apprentice

Group: Status: Switchman
Posts: 19
Joined: 09-July 14
Gender:Male
Simulator:OPEN RAILS
Country:

Posted 15 August 2017 - 07:55 AM

Yes everything is fine in the 2d cab. It is only the 3d cab which is giving me the problem. I have tried this with the style of On/Off as it was in the original 2d cvf and also while pressed and neither causes the button to move at all when I hit the Z key to cancel the alerter. Is there another style that I need to use?

#4 Csantucci

Member, Board of Directors

Group: Status: Elite Member
Posts: 6,996
Joined: 31-December 11
Gender:Male
Country:

Posted 15 August 2017 - 10:38 PM

The 3D cab I provided the link here http://www.elvastowe...post__p__223286 has also the reset button implemented.

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

Elvas Tower: Help with Reset Button - Elvas Tower