[vince]

Hi Goku.

Well, I finally had to use a section of Dynamic Track in my rework of Philadelphia Zoo Interlocking.

I need to adjust the DT for a grade but even using the 'fine' adjust ( Hold Ctrl while tapping 8 or 2 NumPad keys) I cannot get a fine enough adjustment that will have the DT join to an existing track section, a two part Y-Track Turnout.
 DYNTRACKELEVATION.jpg (121.92K)
Number of downloads: 6

Now I do know that normal track can be 'micro' adjusted manually typing into the Gradient Section of the main panel but I see there is no corresponding section for Dynamic Track.
Or perhaps I'm missing something?

Advice please on how to eliminate this annoying 'speed bump' in the Harrisburg Loop trackwork.
Please note that I cannot adjust the track on the left (the higher elevated) side as it is part of a 2 part Y-Track turnout and already is joined on the other leg, and a lot of (too much )re-do of installed track, berms ect. would be required.
Otherwise I'm progressing well with your Editor. Smooooth!
Sincerely,
Vince

[vince]

++ Bump . . . .

regards,vince

[Goku]

You can use a workaround. Change elevation step in track properties to a smaller value.
It will affect all key movements, so you can adjust dynamic track using keys.

[vince]

Thank you Goku, that works. Would like to see that Step setting available on the default TSRE screen too.This Step setting has made those small annoying track laying alignments possible. Be well.

regards,vince