Goku, on 03 July 2017 - 02:47 PM, said:
It is possible. You don't understand me. Look at the image tutorial again.
Well, here's my own tutorial.
First, I place the cross-over section, not attached to any sections of track, as you suggest.
Note that what you see here is one section, that's how UKFS slips are defined.
Slip1_TSRE.jpg (231.78K)
Number of downloads: 6
As you can see in TrackViewer, despite the fact that this trackpiece is 'isolated' as you suggest, no cross-over point is created.
Slip1_TV.jpg (29.55K)
Number of downloads: 6
Next, I insert the switches.
Slip2_TSRE.jpg (217.85K)
Number of downloads: 1
Clearly, still no cross-over point is shown.
Slip2_TV.jpg (26.95K)
Number of downloads: 0
Finally, I add the connecting track sections.
Slip3_TSRE.jpg (229.16K)
Number of downloads: 0
And there is no cross-over point for this slip.
Slip3_TV.jpg (6.32K)
Number of downloads: 0
Now, please tell me what I'm doing wrong and how I could do this otherwise.
But note that there is no cross-over item generated right from the start - there should have been when the first section is placed.
Regards,
Rob Roeterdink