Elvas Tower: Coupler Type display - Elvas Tower

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Coupler Type display Rate Topic: -----

#1 User is offline   cr-stagg 

  • Foreman Of Engines
  • Group: Status: Contributing Member
  • Posts: 909
  • Joined: 16-May 05
  • Gender:Male
  • Simulator:OR
  • Country:

Posted 18 February 2017 - 01:27 PM

Goku,

When an item is selected the data below its picture shows the coupler type. If only one coupler is listed in the ENG file only one type is shown such as "Automatic". But when there are two coupler entries your display shows both types as in "Automatic, Automatic" or "Bar, Automatic". When there are two entries, how does your data entries correspond to the actual coupler on the shape? Is the first listed the front or the rear coupler type?

#2 User is offline   Goku 

  • Superintendant
  • Group: Status: Elite Member
  • Posts: 1,785
  • Joined: 12-December 13
  • Gender:Male
  • Simulator:my own
  • Country:

Posted 18 February 2017 - 01:43 PM

Order in ENG/WAG file.

#3 User is offline   cr-stagg 

  • Foreman Of Engines
  • Group: Status: Contributing Member
  • Posts: 909
  • Joined: 16-May 05
  • Gender:Male
  • Simulator:OR
  • Country:

Posted 18 February 2017 - 01:48 PM

View PostGoku, on 18 February 2017 - 01:43 PM, said:

Order in ENG/WAG file.


Then you are showing Rear, Front.

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users