I see an issue with the OR dynamic track replacement code (see attached pic). The code calculates the tangent and curve sections separately and textures accordingly. The result in the pic is a partial tie on the curve and ties that are a little close of the tangent for the 1st track. Second track shows a bit of a gap instead of a partial tie.
When I create a track section, I always round off to the closest "tie". Is there any chance that this could be improved upon?
Page 1 of 1
Dynamic Track Profile DBTracks US3 Set
#2
Posted 12 July 2016 - 07:34 PM
Here is a track profile for the DBTracks US3 track set, enjoy!
TrProfile.zip (1.54K)
Number of downloads: 542
TrProfile.zip (1.54K)
Number of downloads: 542
#3
#4
Posted 19 July 2016 - 05:48 AM
The textures that I am using in the profile are 10 ties per 5m (US_Track3, US_Track3s).
Page 1 of 1