Log In
Register Now!
Help
From time to time brakes automaticly applys and realise. For example driving 15mph brakes apply to 11BC and then realise to 0. Strange thing. I don't move any button on keybord and any swith on dashboard of loco.
Page 1 of 1
Brake Problem
Rate Topic:
#1
- Conductor
-
- Group: Status: Contributing Member
- Posts: 401
- Joined: 24-June 14
- Gender:Male
- Location:Chrzanów (Małopolska)
- Simulator:Open Rails
-
Country:
Posted 21 November 2015 - 05:31 PM
#2
- Engineer
-
- Group: Status: Contributing Member
- Posts: 638
- Joined: 07-January 13
- Gender:Male
- Simulator:MSTS Open Rails
-
Country:
Posted 21 November 2015 - 07:09 PM
Sounds like you have curve speed dependent checked an exceeded the curve speed limit durability one of your cars couldn't handle at a curve to cause an air hose separation. You can overcome this by opening the con file at least an increasing the durability numbers an testing to your satisfaction.
#3
- Member, Board of Directors
-
- Group: Status: Elite Member
- Posts: 6,999
- Joined: 31-December 11
- Gender:Male
-
Country:
Posted 22 November 2015 - 12:02 AM
You can try release x.3324. I could solve your problem.
#4
- Owner Emeritus and Admin
-
- Group: ET Admin
- Posts: 15,348
- Joined: 11-January 04
- Gender:Male
- Location:United States
- Simulator:Open Rails
-
Country:
Posted 22 November 2015 - 01:19 PM
#5
- Member, Board of Directors
-
- Group: Status: Elite Member
- Posts: 6,999
- Joined: 31-December 11
- Gender:Male
-
Country:
Posted 22 November 2015 - 01:47 PM
I don't suppose it's the same problem. When the brake hose disconnects (which I believe is the effect of too high curve speed), the train brakes.
Page 1 of 1