Elvas Tower: PRR AFP20 (Alco PA) Four Unit Set 2 - 5 Stripe DGLE - Elvas Tower

BLLW PRR PA1 Set 2 for Microsoft Train Simulator
DGLE 5-Stripe Passenger Scheme
Original Shapes and Textures by Dick Cowen
Custom PA1 Cabview by Dwight Mitchell
PRR Textures by Nick Hovey / Tom Pearce
Sounds By Bill Hemb / Eric Cantu. Included with permission.
Installer by Tom Pearce

BACKGROUND

The PA1 locomotive was a joint project of ALCO and GE between September 1946 and June 1950. Each unit in the PA1-PB1 series boasted 2,000 HP from an ALCO 244V16 diesel engine. A total of 173 PA1's were built, with 40 PB1's to compliment them. The Pennsylvania Railroad ordered ten of these PA1's and five of the PB1's in 1947-48. The Pennsy classed them AP20 (Alco, Passenger, 2000 HP), road numbers 5750A-5759A for the PA1's and 5750B-5758B by even road numbers for the PB1's.

INSTALLATION NOTES

To Install This quality add-on:

1. Run the included installer, making sure to pinpoint it to the proper location of your copy of MSTS. (Usually C:\Program Files\Microsoft Games\Train Simulator\Trains\TRAINSET\ ).

2. Then create a consist using ConBuilder (or any consist editing program), and have fun!

3. Sample Consists have been included to allow you to test run the units in A-B, A-B-A, or A-B-B-A setup

SPECIAL THANKS TO:

Dick Cowen, for the amazing PA1 model! It was a pleasure to reskin!

Dwight Mitchell, for the BEST cabviews in MSTS to date. Fully MSTSbin compatible, and good graphics to boot!

Thomas Pearce, for a TON of help getting the nose striping to look right, and for a few last-minute tweaks. If it weren't for you, I'd still have a side-striped unit with no Keystones!

POSTSCRIPT
For accurate Pennsylvania Rolling Stock, please check out our website at http://www.bllw.net/ for more information on our newest projects, release dates, and where to find them! This website is constantly being updated, so check back frequently!